Response SL5 Manuál s instrukcemi stáhnout pdf (Strana 15)

INSTALLING AND CONFIGURING THE

PIR DETECTORS

1. Undo and remove the fixing screw from the

bottom edge of the PIR Detector, (keep the

screw safe for later). Carefully pull the bottom

edge of the detector away from the rear cover

and then slide down to release the top clips.

2. Carefully drill out the required mounting holes in

the rear cover using a 3mm drill according to

whether the unit is being mounted in a corner or

against a flat wall.

3. Using the rear cover as a template, mark the

positions of the fixing holes on the wall.

4. Fix the rear cover to the wall using the two

18mm No.4 screws and 22mm wall plugs,

(a 5mm hole will be required for the wall plugs).

Do not over-tighten the screws as this may

distort or damage the cover.

Note: The wall plugs supplied with the product

are not suitable for plasterboard walls, if

mounting the Detector onto plasterboard use

appropriate wall plugs.

5. To select the required sensitivity, set switch SW3

as follows:

UP HIGH sensitivity

DOWN LOW sensitivity

Note: The recommended setting is HIGH.

However, in cases of extreme environmental

problems or if unexplained false alarms are

experienced, it may be necessary to set the

sensitivity to LOW. Setting the device to LOW

sensitivity will require a greater amount of

movement in order to trigger the device.

6. Connect the PP3 Alkaline battery to the battery

clip. The LED behind the lens will rapidly flash

for approximately 2-3 minutes until the PIR has

stabilised. The LED will then stop flashing and

turn OFF.

TESTING A PIR DETECTOR

INDEPENDENTLY

7. Ensure that the LED indicator has stopped

flashing rapidly.

8. The ‘Test Mode’ button (SW1) is used to put

the PIR Detector into Walk Test Mode, which

overrides the 2 minute sleep period and allows

the operation of the detector to be checked

during installation. Press and hold the button

for 2 seconds to activate Test Mode for a fixed

5 minute after which it will automatically revert

to normal operation.

Rear Cover

Fixing

Screw

Rear Cover

Flat Wall

Mounting

Corner Wall

Mounting

Fixing

Screw

SW2 (Tamper)

SW1 (Test Mode)

SW3

SW3 (Sensitivity)

SW3 up

High Sensitivity

SW3

Sensitivity

Low

SW3

Sensitivity

Low

SW3 down

Low Sensitivity

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Komentáře k této Příručce

Žádné komentáře

Response SL5 Manuál s instrukcemi Strana 15

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SL5