Response SL8 Manuál s instrukcemi stáhnout pdf (Strana 23)

(Optional)

The Control Panel incorporates a terminal block for

connection of a Hard-wired Siren. The connection

terminal block is located inside the Control Panel

behind the front cover. To access the terminal block

you must first put the system into Test Mode to

prevent an alarm occurring.

To do this:

Press

The Arm and Part-Arm LEDs will flash.

Undo the two fixing screws on the top edge of the

Control Panel and open the front cover.

Before making any connections, ensure that the

Reset Jumper Link P1 is in the ’OFF’ position and

then remove the DC power jack and disconnect 1

of the back-up batteries.

The tamper switches should be volt free and

normally closed, with the contacts opening in order

to trigger an alarm.

Note: The External Tamper Switch jumper link P51

should be fitted into the ON position only if the

hardwired tamper circuit is used, otherwise it must

be in the OFF position.

After making your external connections reconnect

the power supply and back-up Battery. Then close

the Control Panel cover and tighten the fixing

screws on the top edge.

EXTERNAL CONNECTIONS

Permanent

12Vdc power

supply output

(100mA max.)

V+

GND

Not used

GND

B+

GND

TAMP

Switched

12Vdc output

for wired Siren

(300mA max.)

GND

OUT

Tamper circuit

connections

for wired Siren

Normally closed

tamper contact

Hardwired

Siren

Terminal Block

External Tamper

Switch Jumper

Link P51

Reset Jumper

Link P1

TAMP GND B+ GND GND V+ OUT GND

TERMINAL

BLOCK DETAIL

OFF ON

Jumper Link

Reset Jumper Link P1

Jumper

ink

ENTER

, ,

User Access Code

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Komentáře k této Příručce

Žádné komentáře

Response SL8 Manuál s instrukcemi Strana 23

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SL8