Response RE3000S Provozní pokyny stáhnout pdf (Strana 22)

OPERATING

INSTRUCTIONS

IMPORTANT

The System cannot be Armed, Part Armed or put into

Test mode if any previous low battery or alarm indication

has not been cleared, (indicated by any Zone LED’s

flashing) or if a Magnetic Detector is open (indicated by

the appropriate Zone LED’s illuminating steadily). When

an attempt is made to Arm the system under any of these

conditions the Control Unit will emit 3 rapid bleeps.

For a low battery condition, replace the detector

battery prior to clearing the indication. To clear a low

battery or alarm indication Enter the Main User or

Second User Access Code, followed by . A low

battery or alarm indication cannot be cleared using the

Remote Control Unit.

FULLY ARMING THE SYSTEM

When leaving the premises, the system must be

fully armed. However, before doing so, check that

all windows are closed and locked, all protected

doors are closed and Passive Infra Red Detectors

are not obstructed. Ensure that pets are restricted

to areas not protected by Passive Infra Red

Detectors or that suitable precautions have been

taken to allow for pets.

The system may be fully armed either at the Control

Unit or using a Remote Control. If Arming at

the Control Unit, you must first Enter your 4 digit

Access Code (Main User or Second User Code) then

press . Alternatively, if Quick Arm has been

programmed, press and hold the button for

5 seconds. If arming using a Remote Control Unit

simply press the green Full Arm button. If the System

exit tone has been set for ‘ON’ the Control Unit sounder

will emit an intermittent bleep tone and the Full Arm LED

will flash for the duration of the preset exit time, Arming

automatically when the exit time expires.

All occupants must leave the premises before the exit time

has expired. If for any reason you are unable to leave the

premises before the exit time has expired, you will need to

disarm the system, then Re-Arm. Failure to do so will

cause a full alarm if any protected door is opened or

movement is detected by a Passive Infra Red Detector.

20 RE5000S Professional Alarm System

Control Unit Terminal

Block Connections

Communicator Interface

Cable Connection

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Komentáře k této Příručce

Žádné komentáře

Response RE3000S Provozní pokyny Strana 22

Komentáře k této Příručce