Response SA1 E Provozní pokyny stáhnout pdf (Strana 21)

ALARM RECORD

You may make a note of your User Access Code and System House Code below.

User Access Code System House Code

Use the above diagram to record your House Code e.g.

This information is condential and should be kept in a safe location.

TROUBLESHOOTING

Symptom / Recommendation

Siren immediately sounds when system armed.

1. Siren tamper switch activated - adjust tamper

plunger and ensure that switch fully closes when

Siren is mounted. If the wall is excessively uneven,

the Siren may need relocating to a more suitable

position.

Siren sounds when system is disarmed or has not

been triggered by an intruder.

1. Detector tamper switch activated - check that the

battery covers of all Detectors and Keypads to

ensure they are securely and fully tted.

2. Personal Attack Alarm operated from a Remote

Control or Keypad.

3. Jamming Detection circuit operation (see page 15).

4. Detector giving false alarm signals, see below.

Siren not responding to Detector.

1. Detector battery low - Replace battery.

2. Siren in Service Mode - switch to Operating Mode

using Remote Control or Keypad.

3. Ensure ‘House Code’ is correctly set to the same

code as all other system devices.

4. Ensure Detector is within effective radio range of

Siren and equipment is not mounted close to metal

objects.

Siren not responding to Remote Control or

Keypad.

1. Remote Control or Keypad battery low – Replace

battery.

2. Ensure ‘House Code’ is correctly set to the same

code as all other system devices.

3. Incorrect User Access Code being entered at

Keypad.

4. Siren rechargeable battery discharged:

a. Clean Solar Panel.

b. Check age of rechargeable battery – replace if

at end of useful life.

c. Fit new initial power-up battery and re-power up

siren.

5. System locked - Reset system:

a. Disconnect Siren rechargeable and initial power-

up batteries.

b. Cover Solar Panel with lightproof material and

leave system for 5 minutes.

c. Reconnect batteries and then remove Solar

panel cover and take out of Service Mode.

LED on Remote Control not illuminating, or is dim

when unit is operated.

1. Ensure battery is tted with correct polarity.

2. Ensure battery holder connections are making good

contact with the battery.

3. Battery low - replace battery.

Keypad not operating (‘On-Air’ light does not

illuminate).

1. Incorrect User Access Code being entered.

2. Battery missing.

1 2 3 4 5 6 7











1 2 ... 16 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře

Response SA1 E Provozní pokyny Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SA1 E