Response SL5 Manuál s instrukcemi stáhnout pdf (Strana 12)

7. Ensure that the Reset Jumper Link (P1) and the

External Tamper Switch Jumper Link (P51) are

set in the OFF position.

8. Connect battery leads to both back-up batteries

and refit batteries.

LEFT Battery: Red lead to the Red (

) battery

terminal

Black lead to the Black (

) battery

terminal

RIGHT Battery: Red lead to the Red (

) battery

terminal

Black lead to the Black (

) battery

terminal

Note: The Power LED may flash to indicate that

the unit is being operated from the back-up

batteries and that mains supply is not present.

9. If fitted, remove the plastic film covering the LCD

display and on the display window on the cover.

10. Close the lid of the Control Panel and fasten the

cover fixing screws.

11. Plug in and switch ON the Power Supply

Adaptor, (the Power LED should illuminate).

12. If required, connect the Control Panel to the

telephone line using the cable supplied by

inserting the small RJ11 plug into socket marked

LINE located on the bottom edge of the Control

Panel. If the cable supplied is not long enough

to reach a suitable phone point then it will need

extending using a coupler and extension lead

(not supplied).

LINKING A REMOTE CONTROL OR

REMOTE KEYPAD TO THE

CONTROL PANEL

If there are already 6 Remote Controls/Keypads

linked to the Control Panel then it will not be possible

to link any more. Attempting to learn a 7th device

will cause the panel to produce a single long beep

and display ‘Cannot Learn - System Full’ message

on screen for 3 seconds.

With unit in Standby mode (Power LED only

illuminated).

1. Press

This puts the Control Panel into Programming

Mode.

‘1. USER SETUP’ will be displayed.

2. Use the and buttons to scroll through

the menu until ‘2. SYSTEM SETUP’ is displayed

and press . ‘2-1 Remotes’ will be displayed.

3. Press again.

The number of Remote Controls/Keypads

already linked will be shown, (e.g. if there are

two Remotes Controls and one Remote Keypad

linked the display will show ‘2.1 Remotes = 3’).

The new Remote Control/Keypad can be programmed

as follows:

4. Press .

OFF ON

Jumper

Link

O. GND V+ OUT GND

External Tamper Switch

Jumper Link P51

Reset Jumper

Link P1

Jumper

Link

Jumper

Link

IMPORTANT: Take care when connecting

battery leads to the batteries as connecting

incorrectly could damage the batteries or the

Control Panel.

ENTER

, ,

Master User Access Code

Note: If the Control Panel Tamper alarm sounds

during the installation reset the alarm by pressing

on the Control

Panel.

IMPORTANT: The keys must be pressed firmly

and within 5 seconds of each other. If you make

a mistake, press and start the sequence again.

ENTER

, ,

User Access Code

ESC

ENTER

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Komentáře k této Příručce

Žádné komentáře

Response SL5 Manuál s instrukcemi Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SL5