Response SL2 Provozní pokyny stáhnout pdf (Strana 11)

3. Ensure that DIP switch 5 of SW3 on the main

board is set to

ON (“C.U.”) for use with this

alarm system.

4. DIP switch 1 marked “ALARM TIME” is used to

limit the maximum period for which the external

siren will sound before it will be automatically

shut down:

ON 3 minutes

OFF 1 minutes

5. DIP switch 2 marked “AJ” controls the anti-

jamming detection facility in the siren:

ON Jamming Detection enabled

OFF Jamming Detection disabled

6. DIP switch 3 marked “ALARM SOUND” if OFF

will prevent the siren from sounding during an

alarm, (this will not affect the warning beeps):

ON Siren enabled

OFF Siren disabled

7. The Solar Siren will acknowledge signals from

the Remote Control or Keypad by beeping and

flashing the LEDs. It is possible to disable these

acknowledgement beeps DIP switch 4 marked

“BEEP SOUND”.

ON Beeps enabled

OFF Beeps disabled

8. Now see Power-Up of the Solar Siren.

POWER-UP OF THE SOLAR SIREN

Note: The use of ear defenders is advisable when

working in close proximity to the Siren due to the high

sound level produced by this device when triggered.

When the system is first installed, it will automatically

power up in Service Mode. It cannot be switched out

of Service Mode and into Operating Mode until at

least one Remote Control or Keypad is link to it.

9. Connect the rechargeable battery to the battery

leads. Connect the Red lead to the Red (

ve)

terminal and the Black lead to the Black (

–

ve)

terminal.

Connect the 9V 6LR61 (PP3) power-up battery

to the battery clip.

10. Press the tamper switch, both indicator LEDs will

flash together several times. The LEDs will then

continue to flash alternately every 5 seconds

thereafter to indicate that the Siren is functioning.

11. If fitted remove the protective film covering the

Solar Panel.

6 Volt 1.2Ah

rechargeable

battery

9 Volt startup

battery

Siren

7.5 Volt DC

charging

adaptor input

ALARM TIME

A J

C.U. OR SIREN

ALARM SOUND

BEEP SOUND

Learn

LED

2345

ALARM TIME

A J

ALARM SOUND

BEEP SOUND

C.U. OR SIREN

2345

ALARM TIME

ALARM SOUND

BEEP SOUND

C.U. OR SIREN

Tamper

Switch

Learn

Switch

Switch SW3

Wall mounting plate

IMPORTANT: Once the batteries have been

connected, the Siren will be operational and it is

important that the solar panel receives sufficient

light to maintain the battery charge. The Siren

should not be operated repeatedly during

installation and testing, as this will rapidly drain

the battery. It is recommended that the Siren be

left for at least a day in order to charge the

battery before the system is Armed.

C.U. OR SIREN

Set to 'ON'

2345

Switch SW3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Response SL2 Provozní pokyny Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SL2