Response SL2 Provozní pokyny stáhnout pdf (Strana 16)

MAGNETIC DOOR/WINDOW

DETECTORS

The Magnetic Door/Window Detector comprises of

two parts; a Detector and a Magnet. They are

designed to be fitted to either doors or windows with

the Magnet mounted on the opening part of the

door/window and the Detector mounted to the frame.

When the protected door or window is opened and

the Magnet is moved away from the Detector an

alarm will be triggered if the system is armed,

(unless the Siren is in Service Mode).

The Door/Window Detector has the facility to

connect an additional wired Magnetic Contact.

This must be of a normally closed contact type with

the contact being opened in order to generate an

alarm condition.

The Door/Window Detector is powered by two

CR2032 type Lithium cells which under normal

conditions will have an expected life of

approximately 1 year. Under normal battery

conditions the LED on the Detector will not

illuminate when the Detector is triggered, (unless

the detector is in Test Mode with the battery cover

removed). However, under low battery conditions

this LED will be illuminated for approximately 1

second when the detector is triggered. When this

occurs the batteries should be replaced as soon as

possible.

Up to a total of 12 detectors (Door/Window

Detectors and/or PIR Movement Detectors) can be

used with the system, providing they are all

mounted within effective radio range of the Siren.

POSITIONING THE DOOR/WINDOW

DETECTORS

The

Door/Window

Detector is suitable for mounting in

dry interior locations only.

Decide which doors and windows are to be protected

by fitting

Door/Window

Detectors, (usually the front

and back doors as a minimum will have Magnetic

Door/Window

Detectors fitted). However additional

detectors may be fitted where required to other more

vulnerable doors or windows, (e.g. garage,

patio/conservatory doors etc).

Ensure that the position selected for the

Door/Window

Detector is within effective range of the Siren.

Do not fix the Detector onto or very close to

metalwork (i.e. radiators, water pipes, etc) as this

could affect the radio range of the device.

On PVC door/window frames, it may be necessary to

space the Detector and Magnet away from the metal

surface using a plastic or wooden spacer to achieve

the necessary radio range.

INSTALLING AND CONFIGURING THE

DOOR/WINDOW DETECTORS

Note: If adding a

Door/Window

Detector to an

installed system, ensure that the Siren is in Service

Mode before commencing installation, (see page 19).

Remember to switch the Siren back to Operating

Mode after installation is complete, (see page 19).

1. Remove the battery cover by sliding and lifting it

off. (DO NOT use a screwdriver to lever it off).

2. Slide the two batteries supplied into the battery

holder, ensuring that the

side is uppermost on

each battery as it is installed.

3. If necessary, refit the battery holder into the

detector ensuring that the spring clip connectors

slide onto either side of the circuit board.

The Detector should be mounted on the fixed part

of the frame and the magnet on the opening part.

Double Sided Tape

OR Screw Fixin

Raised Head Screw,

Key-hole Slot Fixing

Small Counter-sunk

Screw Fixing

Slide Open and Lift Off

Do Not Use A Screwdrive

Battery

Connector

Tilt and Remove

Battery Holder

and Insert

Two Batteries

Fit TWO

Batteries

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Response SL2 Provozní pokyny Strana 16

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SL2