Response SA5 E Provozní pokyny stáhnout pdf (Strana 19)

se the and buttons to scroll through the

menu and press to select the displayed test

function or sub-menu.

Note: After completing all required test functions

press to leave Test mode and return to Standby.

Walk Test

Before commencing testing please ensure that there

is no movement in any PIR protected area, all

doors/windows protected by Magnetic Contact

Detectors are closed and that all battery covers and

housings are correctly fitted.

Scroll through the top level Test Mode menu until

‘WALK TEST’ is displayed and press .

‘Walk Test Waiting…’ will be displayed.

Trigger each detector on the system by either

walking into a PIR protected area or by opening a

door/window protected by a Magnetic Contact

detector. As each detector is triggered the Control

Panel will beep to indicate that an alarm signal has

been received and the identity of the zone that the

detector is configured for will be displayed

Operate detector anti-tamper switches by

opening the case of the device. As the switches

are operated the Control Panel will beep and

‘Accessory Tamper’ will be displayed.

Activate each button on the Remote control in

turn. As each button is pressed the Control panel

will beep and the button name will be displayed,

(e.g. ‘REMOTE CONTROL DISARM’).

Press to exit Walk Test and return to the top

level Test Mode menu.

Alarm Test

Scroll through the top level Test Mode menu until

‘ALARM TEST’ is displayed and press .

Scroll through the menu until the required alarm is

displayed and press to operate the selected

alarm for 5 seconds.

Select ‘Wirefree Siren Test’ to operate the External

Solar Siren.

Select ‘Hardwired Siren Test’ to operate the Control

Panel Siren and external hardwired Siren (if connected).

elect ‘Relay Test’ to operate the External hardwired

(N.O./N.C.) Relay contacts.

Press to exit Alarm Test and return to the top

level Test Mode menu.

Wirefree Siren Service ON/OFF

croll through the top level Test Mode menu until

‘Wirefree Siren Service ON/OFF’ is displayed and

press .

This offers the flexibility of removing or changing

siren’s battery. Wait for 10 seconds until ON/OFF

duration has elapsed, then go ahead with fixing the

siren as desired.

Voice Dialler Test

Scroll through the top level Test Mode menu until

‘VOICE DIALLER TEST’ is displayed and press .

In order to test the voice dialler properly, the

prerequisite is to set the telephone number, record

the message and enable the call routing in the

programming mode.

When testing is in progress, simply press to

stop testing.

If ‘LINE STATUS’ LED is flashing, it implies bad

telephone line connection or telephone network

being out of order. Check the telephone line and re-

test it.

Digital Dialler Test

Scroll through the top level Test Mode menu until

‘DIGITAL DIALLER TEST’ is displayed and press

In order to test the digital dialler properly, the

prerequisite is to set the telephone number and unit

ID number in the programming mode.

When testing is in progress, simply press to

stop testing.

If ‘LINE STATUS’ LED is flashing, it implies two causes

of failure. One is bad telephone line connection or

telephone network being out of order.

The other cause of failure is derived from the central

monitoring station. Consult with the central monitoring

station for help.

ESC

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Komentáře k této Příručce

Žádné komentáře

Response SA5 E Provozní pokyny Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SA5 E