
When leaving the premises, the system should be
Armed. However, before doing so, check that all
w
indows are closed and locked, all protected doors
are closed and PIR Detectors are not obstructed.
Ensure that pets are restricted to areas not
protected by PIR Detectors.
The system has three armed modes, ARM and PART-
ARM 1 and PART-ARM 2. The Part-Arm modes allow
for selected zones to be left in a Disarmed state while
the remainder of the system is Armed.
When the system is Armed (in any mode) the
Control Panel will display the arming mode and the
status of the Latch Key for a few seconds. If
enabled, the system Exit-Delay will start and be
counted down on the display. As the Exit-Delay
expires the Control Panel will beep, with the beep
rate increasing in steps as the delay expires. At the
end of the Exit-Delay all active zones be Armed. By
this time the user must have left the property and
closed the final exit door.
If while the system is armed a detector on an active
zone is triggered, if enabled, the programmed Entry-
Delay for that zone will start and be counted down
on the display. As the Entry-Delay expires the
Control Panel will beep, with the beep rate
increasing in steps as the delay expires. If the
system has not been disarmed when the Entry-
Delay expires an alarm will occur. If however, the
Entry-Delay for the triggered zone has been
disabled an alarm will occur immediately.
At the end of the programmed alarm duration the
Siren and Control Panel alarms will stop and the
system will automatically re-Arm.
Note: The Solar Siren will shut down either after the
programmed alarm duration or after 3 minutes, if the
3 minute limit has been enabled on the Solar Siren.
Arming the System
ARM
The system can be set in ARM mode using either the
Remote Control or the Control Panel as follows:
Remote Control:
Press the ‘ARM’ button .
Control Panel:
Press the Arm button followed by the User Access
Code and then the Enter button:
PART-ARM 1
The system can be set in PART-ARM 1 mode using
either the Remote Control or the Control Panel as
follows:
Remote Control:
Press the ‘PART-ARM’ button .
Control Panel:
Press the Part-Arm button followed by the User
Access Code and then the Enter button:
PART-ARM 2
The system can be set in PART-ARM 2 mode using
either the Remote Control or the Control Panel as
follows:
Remote Control:
Press the ‘PART-ARM’ button twice .
Control Panel:
Press the Part-Arm button followed by the User
Access Code and then the Enter button:
35
Operating Instructions
Komentáře k této Příručce