Response SA5 E Provozní pokyny stáhnout pdf (Strana 36)

Disarming the System

The system can be disarmed using either the Remote

Control or the Control Panel as follows:

Remote Control:

Press the button.

Control Panel:

Press the ‘Disarm’ key, followed by the current User

Access code followed by the ‘Enter’ button

f the system is disarmed and the ‘ALARM MEM’

LED is flashing with the panel beeping every few

seconds, this indicates that an alarm condition has

occurred. Use the Event Log to find out and make

a note of where the alarm occurred to assist in

tracing the cause of the alarm

Quick Set

To operate the quick set function and fully arm the

system in 5 seconds, overriding the programmed exit

delay:-

Press

Omit Zone

To omit a zone from the next armed session:-

Press

Scroll through the menu until the required zone is

displayed. The current setting will also be displayed.

To change the setting press .

Press to omit the zone, (i.e. zone omit ON).

Press to re-enable the zone, (i.e. zone omit

OFF).

After configuring zones to be ommited as required

press to return to Standby mode.

Note: Omitting a zone will only affect the next armed

session. When the system is disarmed the omitted

zones will be re-enabled ready for the next armed

session.

Personal Attack (PA) Alarm

A full Alarm condition can be immediately initiated at

any time (whether the system is Armed or Disarmed)

in the event of threat or danger by activating a Panic

Button on either the Remote Control or the Control

Panel.

Remote Control:

Slide the Panic Button on the side of the Remote

ontrol upwards.

Control Panel:

Press and hold the button for approximately

3 seconds.

The alarm will continue either for the alarm duration

when the system will automatically reset or until the

system is disarmed.

Tamper

If the battery cover of any device is removed or if the

Siren or Control Panel are removed from the wall then

a Full Alarm condition will be initiated even if the

system is Disarmed. The alarm condition will continue

either for the alarm duration when the system will

automatically reset or until the system is Disarmed.

The ‘ALARM MEM’ LED on the Control Panel will

flash and the panel will beep every few seconds to

indicate an alarm has occurred.

Note: The Tamper protection facility on the Siren

operates independently of the Control Panel. If the

Tamper on the Siren is activated this will not be

indicated at the Control Panel.

Chime

The Chime facility can only be operated with the

system in Standby mode.

Press to toggle the Chime facility between ON

and OFF.

Note: If the Chime is ON and the system is then

armed the Chime will remain ON after the system is

disarmed.

Event-Log

The Event Log will store the last 50 system Arm,

disarm, alarm and detector Low Battery events. The

Event Log will record the time, date and detail for

each event.

User Access Code

ESC

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Komentáře k této Příručce

Žádné komentáře

Response SA5 E Provozní pokyny Strana 36

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SA5 E