Response SL5 Provozní pokyny stáhnout pdf (Strana 20)

Fit the top keyhole slots of the mounting plate over

the screw heads. Remove the mounting plate and

adjust the screws until they form a neat fit with the

mounting plate with minimal movement.

5. Secure the mounting plate in position using the

two 25mm fixing screws in the bottom fixing holes.

6. Ensure that the Solar Siren main configuration

switch on the LED indicator board is set to

"SIREN" for use with this alarm system.

7. Undo the 3 screws holding the DIP Switch Cover

in place and remove the cover.

8. Under the cover you will find a series of 9 DIP

switches.

Note: When the Solar Siren is viewed as shown

above (Solar panel at top) the DIP switches are

‘upside down’.

9. DIP switches 1-8 are used to set the House

Code for the Siren and must be set to the same

ON/OFF combination as all other system devices.

10.

If required the maximum length of time that the

External Solar Siren will sound for when activated

under an alarm condition may be limited to 3

minutes using DIP switch 9 as follows:

ON as Control Panel setting

OFF 3 minutes

. The Solar Siren will acknowledge Disarm signals

from the Remote Control and Service Mode

signals by beeping. It is possible to disable these

acknowledgement beeps if required by removing

the jumper link P2 on the circuit board.

P2 fitted beep enabled

P2 removed beep disabled

. If for any reason you need to disable the Siren,

remove jumper link P3 on the circuit board. This

will prevent the Siren from sounding during an

alarm condition. However, the Siren will still beep

to acknowledge signals from the Remote Control,

(provided the beep feature is not disabled).

P3 fitted Siren enabled

P3 removed Siren disabled

To enable the Jamming Detect feature in the Solar

Siren fit the jumper link taped to the cover of the Siren

control unit across link pins P1 on the circuit board.

P1 fitted Jamming Detection enabled

P1 removed Jamming Detection disabled

. Refit the DIP switch cover and replace the three

cover fixing screws. Do not over tighten the screw

as this could damage the thread.

INSTALLATION

Tamper

switch

6 Volt 1.2Ahr

rechargeable

battery

9 Volt PP3 initial

power up battery

Siren

Printed circuit

board enclosure

Receiver

Aerial

DIP switch

cover

Alarm duration

DIP switch 9

House Code

DIP switches 1-8

7.5 Volt DC

charging adaptor

input

Front cover

locating tabs

Beep Disable Lin

Siren Disable Link

Jamming

Detection Link

LED Indicator PCB

Solar Panel

C.U.

Main Configuration Switch

(in SIREN Position)

SIREN

C.U. SIREN

1 2 3 4 5 6 7 8 9

Alarm Duration DIP switch 9

(Always change from the factory setting)

House Code

Main Configuration Switc

(in SIREN Position)

C.U. SIREN

18 SA5

Inside view of Solar Siren with exploded view under set-up panel

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Komentáře k této Příručce

Žádné komentáře

Response SL5 Provozní pokyny Strana 20

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SL5