PROGRAMMING
30 SA5
VOICE DIALLER SETUP
The parameters in this menu allow the configuration of the systems voice dialler. It allows up to four phone numbers to
be entered and the call routing sequence to be configured by defining which number are called and the number of
attempts made to contact each number. The alarm voice messages are also recorded here.
PART-ARM 1
This controls whether the zone is active when Part-Arm
1 is armed.
Default setting: zones 1-4: OFF
zones 5-10: ON
Scroll through the menu until ‘3-6 Z01 Part-Arm 1’
(and the current setting) is displayed.
To change the setting press .
Press to enable the Zone in Part-Arm 1, or
Press to disable the Zone in Part-Arm 1.
PART-ARM 2
This controls whether the zone is active when Part-Arm
2 is armed.
Default setting: OFF (all zones)
Scroll through the menu until ‘3-6 Z01 Part-Arm 2’
(and the current setting ) is displayed.
To change the setting press .
Press to enable the Zone in Part-Arm 2, or
Press to disable the Zone in Part-Arm 2.
WALK THROUGH
This controls whether the zone operates with the
systems “Walk Through“ feature and determines if the
zone is the entry-door or is on the entry-route.
Default setting: OFF
Scroll through the menu until ‘3-8 Z01 Walk Through’
(and the current setting is displayed.
To change the setting press .
Press to enable the Zone in Part-Arm 2, or
Press to disable the Zone in Part-Arm 2.
Note: For the Voice Dialler to operate correctly the “Dial Method” and “Dialler Mode” (see system setup)
must be correctly set and programmed.
4. VOICE DIALLER
Komentáře k této Příručce