Response SL5 Provozní pokyny stáhnout pdf (Strana 42)

OPERATION

40 SA5

EVENT-LOG

The Event Log will store the time, date and event type

of the last 50 system events.

A new system event will be indicated by the ‘ALARM

MEM’ LED flashing and the panel beeping every 10s.

To cancel the LED and stop the beeping you must

access the Event Log or press .

Press to access the Event Log, (from Standby

Mode only):

The Event-Log will automatically display each event in

turn starting with the most recent. The data for each

event is shown on two screens with each screen being

displayed for 5 seconds.

Use and to manually scroll through

the events.

Press to return to standby.

LEAVING A VOICE MEMO MESSAGE

To record a message at the Control Panel using the

Voice Memo facility, proceed as follows:

Press

Press to start recording.

Press to stop the recorder and skip the

remaining message time, (max message duration

is 30s).

Note: The system can only store a maximum of

6 messages, (including answer-phone messages),

if there is no spare message capacity then it will not

be possible to record any message until one has

been deleted.

Messages may be accessed or deleted either at the

Control Panel (see Replay Messages) or via the

“Remote Phone Access And Control” facility.

REPLAYING AND DELETING

MESSAGES AT THE CONTROL PANEL

The presence of any unread memo or answer-phone

messages is indicated o the Control Panel by the

‘MESSAGE’ LED being illuminated.

Messages may be accessed at the Control Panel as

follows:

Press

, ,

Messages are replayed in the order they are

received.

Press during a message to skip to the end

of the message.

At the end of each message there will the option

of deleting the message just heard. To delete the

message.

Press to delete the message.

Press to re-confirm and actually delete the

message.

Note: Press at either stage to cancel

delete and move on to the next message.

After all messages have been replayed the system

will automatically return to Standby Mode.

REMOTE PHONE ACCESS AND

CONTROL

The Remote Phone Access and Control facility, if

enabled, allows you to dial into the system and

recover messages and to monitor/control the basic

alarm system functions.

The control Panel will answer the call after the set

number of rings and emit three beeps on the phone line.

Enter a User Access Code on the telephone keypad.

A valid User Access code will be acknowledged

with one long beep.

An incorrect code will be acknowledged by two

short beeps.

If a User Access Code is not entered within 30s or

is entered incorrectly three times then the Control

Panel will automatically hang-up the line.

Note: If the internal Answer-Phone is also enabled

and there is space for a message then the call will be

answered with the Answer-Phone greeting message.

The User Access Code should be entered before the

greeting message finishes, otherwise the answer-

phone message recorder will be activated.

ESC

ENTER

ESC

? ? ? ?

ENTER

User Access Code

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 51 52

Komentáře k této Příručce

Žádné komentáře

Response SL5 Provozní pokyny Strana 42

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Response SL5